cantieri di pisa atlas for salePre owned

The interiors are made of pickled sandblasted teak – IN PERFECT CONDITION.
- Bow drop for storage and chain shaft
- Sailors' room with two berths, wardrobe, lockers, W.C., shower and sink in a separate room
- Twin master walk-in closet with two closets, dresser, desk, drawers, lockers and two bedside tables
- Master bathroom with electric W.C., bidet, sink and shower
- N. 2 guest cabins with two partially overlapping cross beds, wardrobes and drawers
- Guest bathroom with electric W.C., bidet, sink and shower
- Engine and auxiliary room
Watermaker
additional freezer located in the lazaret in front of the engine room
n. 2 autoclaves
salt water pump on kitchen sink
Intercom in all environments
teak gangway
Gangway and tender davits with electric drive
Flaps
Royal Flush on the left side
external glass covers
Total Cockpit Coverage
Cushions on the foredeck, cockpit and on the flybridge
Navigation equipment:
2 Compass, GPS (Raymarine C120), Chartplotter (Raymarine C120).
Staging and technical:
Engine Alarm, Bilge Alarm, 2 Water pressure pump, 8 Batteries, Deck Shower, Compressor Air System, Gangway, Platform, Automatic Bilge Pump, Manual Bilge Pump, Side door, Teak Cockpit (rifatto recentemente), Shorepower connector, Voltage Rectifier, Electric Windlass, Gang Board (lato sinistro), Living Room Foldable Table, Horn.
Domestic Facilities onboard:
Warm Water System, Inverter Air Conditioning, Watermaker, 220V Outlets, 3 Electric Toilet.
Security equipment:
Barometer, Safety equipment within 50 miles, 2 Liferaft.
Kitchen and appliances:
Galley (3 fuochi), Refrigerator (210 litri).
Accessories notes:
- Opera viva in triple mahogany planking with 2 interposed canvases
- double planking topside of which the inside in armoured marine plywood and the outside in longitudinal courses of mahogany glued with resorcinol glues
- rigid frames of elm reinforced with acacia lamellar and flexible intermediate frames of acacia at less than cm. 10 Interval
- cedar lamellar beams, mahogany lamellar keel and iroko bow wheel
- double planking deck, the upper one of which is made of teak strings 22 mm thick.
- Copper tip finishes riveted on copper washers, silicon bronze screws, and stainless steel bolts.
stanchion bases, various profiles and cable grommets in stainless steel; Other metal parts in Peraluman PE 35 or naval brass.